critical CVSS 9.8 EPSS 0.43%

CVE-2026-64160·Kernel vulnerability

In the Linux kernel, the following vulnerability has been resolved: netfs: Fix potential for tearing in ->remote_i_size and ->zero_point Fix potential tearing in using ->remote_i_size and ->zero_point by copying i_size_read() and i_size_write() and using the same seqcount as for i_size. We need to make sure that netfslib and the filesystems that use it always hold i_lock whilst updating any of the sizes to prevent i_size_seqcount from getting corrupted.

Severity
critical
Software
Kernel
Fixed in
7.0.11
Published

How likely is exploitation

FIRST's Exploit Prediction Scoring System puts the probability of this CVE being exploited in the next 30 days at 0.43% — higher than 36% of all published CVEs. EPSS is an independent forecast of exploitation, not a severity rating: it says nothing about how much damage a successful attack does, which is what a CVSS score measures.

Read the two together. CVE-2026-64160 scores 9.8 on CVSS, so a successful attack would be serious — but at 0.43%, almost nobody is currently attempting it. That is a different situation from a flaw under mass exploitation, and it is usually the difference between patching on your next maintenance window and patching tonight.

Affected versions

From: 5.18

Until: 7.0.11

Fixed in: 7.0.11

How to fix this CVE

Update your Linux kernel to version 7.0.11 or later to patch a critical race condition in the netfs subsystem that could lead to memory corruption. This vulnerability affects the synchronization of file size metadata and requires immediate kernel patching and system reboot to take effect.

sudo dnf update kernel kernel-devel && sudo reboot

Defensia detects this vulnerability

How to check if you are affected

  1. Run 'uname -r' to check your current kernel version and verify if it falls within the affected range (5.18 to 7.0.10)
  2. Check if netfs is compiled into your kernel by running 'grep CONFIG_NETFS /boot/config-$(uname -r)' — if set to 'y' or 'm', netfs is present
  3. Search kernel logs for signs of memory corruption: 'sudo dmesg | grep -iE "(page fault|segfault|data abort|general protection fault)"' — correlate timestamps with network file operations
  4. After patching, confirm the fix with 'uname -r' returning a kernel version ≥7.0.11 and verify no new memory errors in 'sudo dmesg' after reboot

FAQ

What is CVE-2026-64160?

This vulnerability is a race condition in the Linux kernel's netfs subsystem where concurrent access to file size metadata (remote_i_size and zero_point) can cause data corruption due to improper seqcount synchronization. Attackers with local or network access to systems using netfs-based filesystems could trigger memory corruption leading to privilege escalation or denial of service.

Is CVE-2026-64160 being actively exploited?

No. This vulnerability is not currently listed on CISA's Known Exploited Vulnerabilities (KEV) catalog and no public exploits are available. However, the critical CVSS score (9.8) warrants immediate patching as a proof-of-concept could emerge.

What versions of Kernel are affected by CVE-2026-64160?

Kernel versions 5.18 through 7.0.10 are affected. Version 7.0.11 and later contain the fix. Users on older stable branches (5.15, 6.1, 6.6) should check their distribution's backport status.

How do I check if my server is vulnerable to CVE-2026-64160?

Run 'uname -r' to get your kernel version. If the output is between 5.18 and 7.0.10 (inclusive) and netfs is enabled ('grep CONFIG_NETFS /boot/config-$(uname -r)'), your system is vulnerable and requires immediate updating.

Does Defensia detect CVE-2026-64160?

Yes — Defensia's CVE advisory scanner compares installed package versions against the NVD database. If Kernel is installed on a monitored server, CVE-2026-64160 will appear in your dashboard with remediation steps.

Related Kernel CVEs

CVE-2026-63795CVSS 10In the Linux kernel, the following vulnerability has been resolved: 9p: avoid putting oldfid in p9_client_walk() error path When p9_client_walk() is called with clone set to false, fid aliases oldfid. If the walk subsequently fails after the request has been sent, the error path jumps to clunk_fid, which currently calls p9_fid_put(fid) unconditionally. This drops a reference to oldfid even though ownership of oldfid remains with the caller. If this is the last reference, oldfid can be clunked and destroyed while the caller still expects it to be valid. A later use or put of oldfid can then trigger a use-after-free or refcount underflow. Fix this by only putting fid in the clunk_fid error path when it does not alias oldfid, matching the existing guard in the error path below. This can be triggered when a multi-component walk is split into multiple p9_client_walk() calls and a later non-cloning walk fails. A reproducer and refcount warning logs are available on request.
CVE-2026-52955CVSS 9.8In the Linux kernel, the following vulnerability has been resolved: libceph: Fix potential out-of-bounds access in crush_decode() A message of type CEPH_MSG_OSD_MAP containing a crush map with at least one bucket has two fields holding the bucket algorithm. If the values in these two fields differ, an out-of-bounds access can occur. This is the case because the first algorithm field (alg) is used to allocate the correct amount of memory for a bucket of this type, while the second algorithm field inside the bucket (b->alg) is used in the subsequent processing. This patch fixes the issue by adding a check that compares alg and b->alg and aborts the processing in case they differ. Furthermore, b->alg is set to 0 in this case, because the destruction of the crush map also uses this field to determine the bucket type, which can again result in an out-of-bounds access when trying to free the memory pointed to by the fields of the bucket. To correctly free the memory allocated for the bucket in such a case, the corresponding call to kfree is moved from the algorithm-specific crush_destroy_bucket functions to the generic crush_destroy_bucket().
CVE-2026-53384CVSS 9.8In the Linux kernel, the following vulnerability has been resolved: serial: 8250_dw: unregister 8250 port if clk_notifier_register() fails dw8250_probe() registers the 8250 port via serial8250_register_8250_port() and then, if the device has a clock, registers a clock notifier. If clk_notifier_register() fails, probe returns the error but leaves the 8250 port registered. The matching serial8250_unregister_port() lives in dw8250_remove(), which is not called when probe fails, so the port slot stays occupied until the device is rebound or the system is rebooted. The devm-allocated driver data is freed while the port still references it (via the saved private_data and serial_in/serial_out callbacks), so any access to that port slot before a rebind is a use-after-free hazard. Unregister the port on the clk_notifier_register() error path.
CVE-2026-53399CVSS 9.8In the Linux kernel, the following vulnerability has been resolved: nfsd: release layout stid on setlease failure nfs4_alloc_stid() publishes the new stid into cl->cl_stateids via idr_alloc_cyclic() under cl_lock before returning to nfsd4_alloc_layout_stateid(). When nfsd4_layout_setlease() then fails, the error path frees the layout stateid directly with kmem_cache_free() without ever calling idr_remove(), leaving the IDR slot pointing at freed slab memory. Any subsequent IDR walker (states_show, client teardown) dereferences the dangling pointer. The correct teardown for an IDR-published stid is nfs4_put_stid(), which removes the IDR slot under cl_lock, dispatches sc_free (nfsd4_free_layout_stateid) to release ls->ls_file via nfsd4_close_layout(), and drops the nfs4_file reference in its tail. A second issue blocks that switch: nfsd4_free_layout_stateid() unconditionally inspects ls->ls_fence_work via delayed_work_pending() under ls_lock, but INIT_DELAYED_WORK(&ls->ls_fence_work, ...) currently runs only after the setlease call. On the setlease-failure path the destructor would touch an uninitialized delayed_work. nfsd4_alloc_layout_stateid() nfs4_alloc_stid() /* idr_alloc_cyclic under cl_lock */ nfsd4_layout_setlease() /* fails */ nfs4_put_stid() nfsd4_free_layout_stateid() delayed_work_pending(&ls->ls_fence_work) /* needs INIT */ nfsd4_close_layout() /* nfsd_file_put(ls->ls_file) */ put_nfs4_file() Fix by hoisting the ls_fenced / ls_fence_delay / INIT_DELAYED_WORK initialization above the nfsd4_layout_setlease() call, and replace the manual nfsd_file_put + put_nfs4_file + kmem_cache_free cleanup with a single nfs4_put_stid(stp).
CVE-2026-53260CVSS 9.8In the Linux kernel, the following vulnerability has been resolved: tcp: Add preempt_{disable,enable}_nested() in reqsk_queue_hash_req(). syzbot reported a weird reqsk->rsk_refcnt underflow in __inet_csk_reqsk_queue_drop(). The captured reqsk_put() in __inet_csk_reqsk_queue_drop() is called only when it successfully removes reqsk from ehash. Moreover, reqsk_timer_handler() calls another reqsk_put() after that. This indicates that the reqsk was missing both refcnts for ehash and the timer itself. Since all the syzbot reports had PREEMPT_RT enabled, the only possible scenario is that reqsk_queue_hash_req() is preempted after mod_timer() and before refcount_set(), and then the timer triggered after 1s aborts the reqsk due to its listener's close(). Let's wrap mod_timer() and refcount_set() with preempt_disable_nested() and preempt_enable_nested(). Note that inet_ehash_insert() holds the normal spin_lock() (mutex in PREEMPT_RT), so it must be called outside of preempt_disable_nested(), but this is fine. The lookup path just ignores 0 sk_refcnt entries in ehash and tries to create another reqsk, but this will fail at inet_ehash_insert(). [0]: refcount_t: underflow; use-after-free. WARNING: lib/refcount.c:28 at refcount_warn_saturate+0xb2/0x110 lib/refcount.c:28, CPU#0: ktimers/0/16 Modules linked in: CPU: 0 UID: 0 PID: 16 Comm: ktimers/0 Tainted: G L syzkaller #0 PREEMPT_{RT,(full)} Tainted: [L]=SOFTLOCKUP Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 04/18/2026 RIP: 0010:refcount_warn_saturate+0xb2/0x110 lib/refcount.c:28 Code: e4 7d d1 0a 67 48 0f b9 3a eb 4a e8 38 3d 23 fd 48 8d 3d e1 7d d1 0a 67 48 0f b9 3a eb 37 e8 25 3d 23 fd 48 8d 3d de 7d d1 0a <67> 48 0f b9 3a eb 24 e8 12 3d 23 fd 48 8d 3d db 7d d1 0a 67 48 0f RSP: 0000:ffffc90000157948 EFLAGS: 00010246 RAX: ffffffff84a1301b RBX: 0000000000000003 RCX: ffff88801ca98000 RDX: 0000000000000100 RSI: 0000000000000000 RDI: ffffffff8f72ae00 RBP: ffffffff99ae3b01 R08: ffff88801ca98000 R09: 0000000000000005 R10: 0000000000000100 R11: 0000000000000004 R12: ffff8880425ef568 R13: ffff8880425ef4f8 R14: ffff8880425ef578 R15: 0000000000000000 FS: 0000000000000000(0000) GS:ffff888126386000(0000) knlGS:0000000000000000 CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033 CR2: 00007f7b46710e9c CR3: 000000000dbb6000 CR4: 00000000003526f0 Call Trace: <TASK> __refcount_sub_and_test include/linux/refcount.h:400 [inline] __refcount_dec_and_test include/linux/refcount.h:432 [inline] refcount_dec_and_test include/linux/refcount.h:450 [inline] reqsk_put include/net/request_sock.h:136 [inline] __inet_csk_reqsk_queue_drop+0x3ce/0x440 net/ipv4/inet_connection_sock.c:1007 reqsk_timer_handler+0x651/0xdf0 net/ipv4/inet_connection_sock.c:1137 call_timer_fn+0x192/0x5e0 kernel/time/timer.c:1748 expire_timers kernel/time/timer.c:1799 [inline] __run_timers kernel/time/timer.c:2374 [inline] __run_timer_base+0x6a3/0x9f0 kernel/time/timer.c:2386 run_timer_base kernel/time/timer.c:2395 [inline] run_timer_softirq+0x67/0x170 kernel/time/timer.c:2403 handle_softirqs+0x1de/0x6d0 kernel/softirq.c:622 __do_softirq kernel/softirq.c:656 [inline] run_ktimerd+0x69/0x100 kernel/softirq.c:1151 smpboot_thread_fn+0x541/0xa50 kernel/smpboot.c:160 kthread+0x388/0x470 kernel/kthread.c:436 ret_from_fork+0x514/0xb70 arch/x86/kernel/process.c:158 ret_from_fork_asm+0x1a/0x30 arch/x86/entry/entry_64.S:245 </TASK>

References

Track CVEs across your fleet automatically

Defensia scans your Linux servers and tells you exactly which ones are running vulnerable versions — including CVE-2026-64160. Free for 1 server.

Get started free